Frequently Asked Questions for Temp-Coat Insul-All

Q: How Does TempCoat Insul-All work?

A: The insulating power is based on the millions of tiny hollow micro-spheres contained in the product. These spheres move heat at a much slower rate than it would be if there was no insulation, therefore, the heat or cold is retained or transfer prevented, depending on your application.

Q: What insulating value does TempCoat Insul-All provide?

A: A 15 mil coating will compare to a R-19 rating, which will provide the same insulation value as 4 inches of foam or 6 inches of fiberglass. For more insulation at higher temperatures for example, more layers of the product are applied.

Q: Do you have tests to prove this?

A: Many tests have been conducted with TempCoat Insul-All over the 15 years since it's introduction. The Thermal Properties Laboratory of Purdue University, USA has provided a test result that is most conclusive about the insulating power.

Q: Where can I apply TempCoat Insul-All?

A: TempCoat Insul-All can be applied to almost any clean and dry surface where you need insulation. The only surfaces to which we do not recommend application are Teflon or silicone.

Q: What is the primary benefit of TempCoat Insul-All v. Other Insulations?

A: There are several. One is that it takes much less space to install than other insulations. A second is that by sealing the surface needing insulation, corrosion is significantly reduced or eliminated. A third primary benefit is that it is much easier to install than conventional insulation, and there are often major savings in labor.

Q: How do I apply TempCoat Insul-All?

A: The product is applied by spray application in 15-20 mil coatings. It can be sprayed with conventional airless spray equipment, or, for small jobs, our Quick Gun can be used.

Q: How long can I expect TempCoat Insul-All to last? The weather conditions in my area are pretty severe.

A: TempCoat Insul-All is not generally affected by exposure to the elements. Many jobs we have completed more than 10 years ago are still in perfect service, outdoors as well.

Q: Our steam pipes occasionally go up to over 300F. Are there limitations for this product?

A: TempCoat Insul-All can be used at operating temperatures of –80F to 250F, so this would be an application for Temp Coat 101S, which has a higher temperature operating tolerance.

Q: What is the difference between TempCoat 101S and Insul-All, and in which application would you recommend one over the other?

A: The main difference is temperature tolerance; TempCoat 101S has a higher temperature rating. Another one is application. TempCoat101S must be spray applied, whereas Temp Coat Insul-All has special polymers added that allow it to be applied with a brush or roller.

Q: Is there technical information available?

A: Please contact us for whatever you may require.

Q: Do you supply technical support?

A: We have a trained certified technical support team. If you need assistance in specifying a job, establishing a trial, or even installing the products, please call us.

Q: Is TempCoat Insul-All difficult to maintain once it is installed?

A: TempCoat Insul-All, once applied requires no additional maintenance to the surface.

Q: What is one of the best awards or approvals that TempCoat Insul-All has achieved?

A: We are proud to say that TempCoat Insul-All is an authorized Energy Star product. It has been used in thousands of consumer and commercial applications around the globe.